Toyota Venza: Problem Symptoms Table
PROBLEM SYMPTOMS TABLE
- Use the table below to help determine the cause of problem symptoms. If multiple suspected areas are listed, the potential causes of the symptoms are listed in order of probability in the "Suspected Area" column of the table. Check each symptom by checking the suspected areas in the order they are listed. Replace parts as necessary.
- Inspect the fuses and relays related to this system before inspecting the suspected areas below.
|
Symptom |
Suspected Area |
See page |
|---|---|---|
|
Only Driver Door LOCK/UNLOCK Functions do not Operate |
Front door lock assembly LH |
|
|
Wire harness or connector |
- |
|
|
Main body ECU (Driver side junction block assembly) |
- |
|
|
Only Front Passenger Door LOCK/UNLOCK Functions do not Operate |
Front door lock assembly RH |
|
|
Wire harness or connector |
- |
|
|
Main body ECU (Driver side junction block assembly) |
- |
|
|
Only Rear Door LH LOCK/UNLOCK Functions do not Operate |
Rear door lock assembly LH |
|
|
Wire harness or connector |
- |
|
|
Main body ECU (Driver side junction block assembly) |
- |
|
|
Only Rear Door RH LOCK/UNLOCK Functions do not Operate |
Rear door lock assembly RH |
|
|
Wire harness or connector |
- |
|
|
Main body ECU (Driver side junction block assembly) |
- |
|
|
All Doors LOCK/UNLOCK Functions do not Operate Via Master Switch, Driver Side Door Key Cylinder |
LIN communication system |
|
|
Power window regulator master switch assembly |
- |
|
|
Front door lock assembly LH |
- |
|
|
Wire harness or connector |
- |
|
|
Main body ECU (Driver side junction block assembly) |
- |
|
|
All Doors LOCK/UNLOCK Functions do not Operate Via Door Control Switch |
Door control switch assembly |
|
|
Wire harness or connector |
- |
|
|
Main body ECU (Driver side junction block assembly) |
- |
|
|
Only Back Door cannot be Opened |
Back door closer system |
|
.gif)
Customize Parameters
CUSTOMIZE PARAMETERS
1. CUSTOMIZING FUNCTION WITH TECHSTREAM
HINT:
The following items can be customized.
NOTICE:
When the customer requests a change in a function, first make sure that
...
Terminals Of Ecu
TERMINALS OF ECU
1. CHECK MAIN BODY ECU (DRIVER SIDE JUNCTION BLOCK ASSEMBLY)
(a) Disconnect the 2C, 2F and 2K main body ECU (driver side junction block assembly)
connectors.
(b) Measure the vo ...
Other materials about Toyota Venza:
Washer fluid
If any washer does not work or the low windshield washer fluid level warning
light comes on, the washer tank may be empty. Add washer fluid.
CAUTION
- When refilling the washer fluid
Do not refill the washer fluid when the engine is hot or running ...
No Response from Steering Lock ECU (B2786)
DESCRIPTION
This DTC is stored when LIN communication between the certification ECU (smart
key ECU assembly) and steering lock ECU (steering lock actuator assembly) stops
for more than 10 seconds.
DTC No.
DTC Detection Condition
...
Malfunction in Deceleration Sensor (C0365/28,C1234/34,C1245/32,C1245/45)
DESCRIPTION
The skid control ECU receives signals from the yaw rate and acceleration sensor
via the CAN communication system.
The yaw rate sensor has a built-in acceleration sensor.
If there is trouble in the bus lines between the yaw rate and acceleratio ...
0.1548