Toyota Venza: Precaution

HINT:

• Any digits beyond the 0.01 mm (1/1000 in.) place for standard, minimum and maximum values should be used as a reference only.
• When both standard and maximum or minimum values are listed for an inspection, use the standard value as a reference only and base any judgments on the maximum and minimum values.

Cylinder Head

Components

Other materials about Toyota Venza:

Mass Air Flow Circuit Range / Performance Problem (P0101)
DESCRIPTION Refer to DTC P0102 (See page ). DTC No. DTC Detection Condition Trouble Area P0101 All of the following conditions are met (2 trip detection logic): (a) The engine is running. (b ...

Inspection
INSPECTION PROCEDURE 1. INSPECT POWER WINDOW REGULATOR SWITCH ASSEMBLY (for Rear LH) (a) Check the switch function. (1) Measure the resistance according to the value(s) in the table below. Standard Resistance: Tester Co ...

Room Oscillator does not Recognize Key
DESCRIPTION If the room oscillator does not recognize a key, one of the following may be the cause: 1) communication between the indoor electrical key oscillator (for front floor) and key cannot be performed; 2) communication between the indoor electrical ...