Toyota Venza: PBD Pulse Sensor Malfunction (B2222)

Toyota Venza Service Manual / Door / Hatch / Power Back Door System / PBD Pulse Sensor Malfunction (B2222)

DESCRIPTION

A pulse sensor is built into the power back door ECU (power back door motor unit) to detect foreign objects and the back door position. The pulse sensor monitors the operating speed of the back door to detect foreign objects. The pulse sensor is also used to monitor the back door position. If a pulse signal that is out of the normal range is output, the power back door ECU (power back door motor unit) will store DTC B2222.
If DTC B2222 is stored, the power back door system will be turned off and the back door will be switched to manual operation mode (not electrically controlled).

In order to restore the power back door system to normal operation mode, first solve the problem indicated by DTC B2222 and then fully close the back door manually (reset operation).

DTC No.	DTC Detection Condition	Trouble Area
B2222	The power back door ECU (Power back door motor unit) does not operate.	Power back door ECU (Power back door motor unit)

PROCEDURE

1.	CHECK FOR DTC

(a) Check for DTCs (See page ).

(b) Clear the DTCs (See page ).

OK:

DTC B2222 is not output.

USE SIMULATION METHOD TO CHECK

REPLACE POWER BACK DOOR ECU (POWER BACK DOOR MOTOR UNIT)

Diagnostic Trouble Code Chart

DIAGNOSTIC TROUBLE CODE CHART HINT: If a trouble code is displayed during the DTC check, inspect the trouble areas listed below for that code. For details of the code, refer to the following " ...

Back Door Motor Clutch Malfunction (B2225)

DESCRIPTION When an electrical malfunction (open or short) is detected in the clutch circuit of the power back door ECU (power back door motor unit) while the power back door is operating, the po ...

Other materials about Toyota Venza:

Rear Brake Flexible Hose
Components COMPONENTS ILLUSTRATION Removal REMOVAL CAUTION / NOTICE / HINT NOTICE: If both the left and right side hoses are removed at the same time, be sure to place identification marks indicating the position on each side. HINT: Us ...

Lost Communication with Rear Airbag Sensor LH (B1637/82,B1638/82,B1647/82,B1697/82,B1698/82)
DESCRIPTION The side collision sensor LH circuit (to determine deployment of the front seat side airbag assembly LH and curtain shield airbag assembly LH) is composed of the center airbag sensor assembly, rear airbag sensor LH and side airbag sensor LH. ...

Navigation Receiver Assembly Communication Stop Mode
DESCRIPTION Detection Item Symptom Trouble Area Navigation Receiver Assembly Communication Stop Mode "Display and Navigation (AVN1)" is not displayed on the "CAN Bus ...