Toyota Venza: Installation
INSTALLATION
PROCEDURE
1. INSTALL DRIVE MONITOR SWITCH
|
(a) Engage the 4 claws to install the driver monitor switch. |
|
.png)
2. INSTALL RADIO AND DISPLAY RECEIVER ASSEMBLY WITH BRACKET (for Radio and Display Type)
.gif)
3. INSTALL NAVIGATION RECEIVER ASSEMBLY WITH BRACKET (for Navigation Receiver Type)
4. INSTALL NO. 2 INSTRUMENT PANEL SPEAKER PANEL SUB-ASSEMBLY
5. INSTALL CONSOLE BOX SUB-ASSEMBLY
6. INSTALL POSITION INDICATOR HOUSING ASSEMBLY
7. INSTALL SHIFT LEVER KNOB SUB-ASSEMBLY
8. INSTALL LOWER INSTRUMENT PANEL SUB-ASSEMBLY
9. INSTALL NO. 2 INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY
10. INSTALL COWL SIDE TRIM SUB-ASSEMBLY RH
HINT:
Use the same procedure for the RH side and LH side.
11. INSTALL FRONT DOOR SCUFF PLATE RH
HINT:
Use the same procedure for the RH side and LH side.
12. INSTALL LOWER NO. 1 INSTRUMENT PANEL FINISH PANEL
13. INSTALL COWL SIDE TRIM SUB-ASSEMBLY LH
14. INSTALL FRONT DOOR SCUFF PLATE LH
15. INSTALL AIR CONDITIONING CONTROL ASSEMBLY
16. INSTALL CONSOLE BOX ASSEMBLY
17. INSTALL NO. 2 CONSOLE BOX CARPET
18. INSTALL UPPER CONSOLE PANEL SUB-ASSEMBLY (w/o Seat Heater System)
19. INSTALL UPPER CONSOLE PANEL SUB-ASSEMBLY (w/ Seat Heater System)
Removal
REMOVAL
PROCEDURE
1. REMOVE UPPER CONSOLE PANEL SUB-ASSEMBLY (w/o Seat Heater System)
2. REMOVE UPPER CONSOLE PANEL SUB-ASSEMBLY (w/ Seat Heater System)
3. REMOVE NO. 2 CONSOLE BOX CARPET
...
Other materials about Toyota Venza:
Inspection
INSPECTION
PROCEDURE
1. INSPECT DRIVE MONITOR SWITCH
(a) Measure the resistance according to the value(s) in the table below.
Standard Resistance:
Tester Connection
Switch Condition
Specif ...
Adjustment
ADJUSTMENT
CAUTION / NOTICE / HINT
HINT:
Centering bolts are used to mount the hood hinge and hood lock. The
hood and hood lock cannot be adjusted with the centering bolts installed.
Substitute the centering bolts with standard bolts when ...
Precaution
PRECAUTION
1. PRECAUTION FOR DISCONNECTING CABLE FROM NEGATIVE BATTERY TERMINAL
NOTICE:
When disconnecting the cable from the negative (-) battery terminal, initialize
the following system after the terminal is reconnected:
System Name
...
0.1473