Toyota Venza: How To Proceed With Troubleshooting

Toyota Venza Service Manual / Door Lock / Power Door Lock Control System / How To Proceed With Troubleshooting

CAUTION / NOTICE / HINT

HINT:

Use the following procedure to troubleshoot the power door lock control system.
*: Use the Techstream.

PROCEDURE

1.	VEHICLE BROUGHT TO WORKSHOP

2.	CUSTOMER PROBLEM ANALYSIS

HINT:

In troubleshooting, confirm that the problem symptoms have been accurately identified. Preconceptions should be discarded in order to make an accurate judgment. To clearly understand what the problem symptoms are, it is extremely important to ask the customer about the problem and the conditions at the time the malfunction occurred.
Gather as much information as possible for reference. Past problems that seem unrelated may also help in some cases.
The following 5 items are important points for problem analysis:

What	Vehicle model, system name
When	Date, time, occurrence frequency
Where	Road conditions
Under what conditions?	Running conditions, driving conditions, weather conditions
How did it happen?	Problem symptoms

3.	INSPECT BATTERY VOLTAGE

(a) Measure the battery voltage.

Standard Voltage:

11 to 14 V

If the voltage is below 11 V, recharge or replace the battery before proceeding to the next step.

4.	INSPECT COMMUNICATION FUNCTION OF CAN COMMUNICATION SYSTEM*

(a) Use the Techstream to check if the LIN communication system is functioning normally (See page ).

Result	Proceed to
LIN DTC is not output	A
LIN DTC is output	B

GO TO DIAGNOSTIC TROUBLE CODE CHART

5.	PROBLEM SYMPTOMS TABLE

(a) Refer to Problem Symptoms Table (See page ).

Result	Proceed to
Fault is not listed in Problem Symptoms Table	A
Fault is listed in Problem Symptoms Table	B

GO TO STEP 7

6.	OVERALL ANALYSIS AND TROUBLESHOOTING*

(a) Terminals of ECU (See page )

(b) Data List / Active Test (See page )

7.	REPAIR OR REPLACE

8.	CONFIRMATION TEST

END

System Description

SYSTEM DESCRIPTION 1. POWER DOOR LOCK CONTROL SYSTEM DESCRIPTION (a) The power door lock system locks/unlocks all doors. The door control switch sends "lock/unlock" request signals to the ...

Operation Check

OPERATION CHECK 1. CHECK POWER DOOR LOCK CONTROL OPERATION NOTICE: The following procedure is based on the assumption that the functions have not been customized using the Techstream. (a) Check ...

Other materials about Toyota Venza:

Terminals Of Ecu
TERMINALS OF ECU 1. CHECK TRANSPONDER KEY AMPLIFIER (a) Disconnect the D21 transponder key amplifier connector. (b) Measure the resistance according to the value(s) in the table below. HINT: Measure the values on the wire harness side with connector dis ...

Inspection
INSPECTION PROCEDURE 1. INSPECT ENGINE COOLANT TEMPERATURE SENSOR Text in Illustration *1 Component without harness connected (Engine Coolant Temperature Sensor) *2 Temperature °C (°F) *3 ...

Installation
INSTALLATION PROCEDURE 1. INSTALL REAR SEAT INNER BELT ASSEMBLY LH (a) Install the rear seat inner belt assembly LH with the bolt. Text in Illustration *1 Protruding Part Torque: 42 N� ...