Toyota Venza: Front Power Seat Control System(w/o Memory)

Power Seat Power Easy Access System Function does not Operate

DESCRIPTION When the ignition switch is off and shift lever is in P, the power seat slides rearward when the seat belt tongue plate is disengaged from the front seat inner belt assembly LH (auto ...

Precaution

PRECAUTION 1. NOTICE FOR INITIALIZATION HINT: When disconnecting the cable from the negative (-) battery terminal, initialize the following systems after the cable is reconnected. Sys ...

Other materials about Toyota Venza:

Disassembly
DISASSEMBLY PROCEDURE 1. REMOVE ULTRASONIC SENSOR CLIP (w/ Intuitive Parking Assist System) 2. REMOVE NO. 1 ULTRASONIC SENSOR (w/ Intuitive Parking Assist System) 3. REMOVE NO. 1 ULTRASONIC SENSOR RETAINER (w/ Intuitive Parking Assist System) 4. ...

Installation
INSTALLATION CAUTION / NOTICE / HINT HINT: Perform "Inspection After Repair" after replacing the engine assembly (See page ). PROCEDURE 1. INSTALL IGNITION COIL ASSEMBLY 2. INSTALL FUEL DELIVERY PIPE SUB-ASSEMBLY 3. INSTALL ENGINE COOL ...

Terminals Of Ecu
TERMINALS OF ECU 1. CHECK SLIDING ROOF ECU (SLIDING ROOF DRIVE GEAR SUB-ASSEMBLY) (a) Disconnect the P4 ECU connector. (b) Measure the resistance and voltage according to the value(s) in the table below. HINT: Measure the values on the wire harness si ...